Table of Contents
Advertisement
Quick Links
INSTALLATION, SERVICE & PARTS MANUAL
Power Flo Pumps & Systems 877 24PUMPS www powerflopumps com
Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com
Series:
PFG2002HV & HH
PFG2022HV & HH
PFG2062HV & HH
PFG2032HV & HH
PFG2042HV & HH
2 HP • 3450 RPM • 60 Hz
Submersible Grinder Pump
BACK TO INDEX
Double Seal
ISP No: PFGrinder - 9/09
Advertisement
Table of Contents
Related Manuals for Power-flo PFG2002HV
Summary of Contents for Power-flo PFG2002HV
- Page 1 Double Seal 2 HP • 3450 RPM • 60 Hz Submersible Grinder Pump Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com Power Flo Pumps & Systems 877 24PUMPS www powerflopumps com ISP No: PFGrinder - 9/09 BACK TO INDEX...
-
Page 2: General Safety Information
Volts L3-1: 877-24 PUMPS www.powerflopumps.com ® Power-Flo is a registered trademark of Power-Flo Technologies Inc. Other brand and product names are trademarks or registered trademarks of their respective holders. Alteration Rights Reserved. 11/2007 - 3/08, 9/08, 6/09, 9/09 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com... - Page 3 2 HP • 3450 RPM • 60 Hz Submersible Grinder Pump Description Designed to reduce domestic, commercial, institutional and light industrial sewage to a fi nely ground slurry. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 4 (*) IMPORTANT! - These pumps require a control panel with start, run capacitors and relay. Capacitor kits which include Start & Run capacitors and Start relay, are available if a Power-Flo control panel is not used. See page 13 for wiring schematic.
- Page 5 PFG-HH, 2HP Submersible Grinder Pumps Performance Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 6 PFG-HV 2HP Submersible Grinder Pumps Performance Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
-
Page 7: Receiving And Installation
Do not ENTRANCE OF SEWAGE SOLIDS MUST BE A MINIMUM OF 3 8” pump out of liquid. INCHES TO A MAXIMUM OF 4.5 INCHES. Bottom of Feet Figure 1 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX... - Page 8 The thermal sensor will trip when used to manually stop system flow the windings become too hot and will during pump servicing. automatically reset when the pump motor cools to a safe temperature. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
-
Page 9: Installation & Service
Tolocate the leak, perform a pressure Figure 2 test. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX... - Page 10 Do Not store pump Overfilling oil voids warranty. replaced. without impeller in place. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 11 (15). Be sure terminal block is engaged and install retaining ring (38). Place cap screws (35) with lockwashers (11) through housing (15) into intermediate coupling (21) and tighten. (See Figure 4) Figure 3 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 12 (24) is not twisted and in the groove. Place two capscrews (32) with lockwashers (11) into seal plate and Figure 6 torque to 6.5 ft/lbs. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 13 Figure 7 - 460 Volt, 3Phase 1Phase Capacitor & Relay Pack For Control Panels: 2HP, 200 V, 1 Ph - P/N: PF88243 2HP, 230 V, 1PH - P/N: PF73306 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 14 PFG - HH & HV 2HP Submersible Grinder Pumps Typical Panel Wiring Schematic Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
-
Page 15: Repair Parts
For Repair Part Please supply: Model Number and MFG Date as shown on Repair Parts Name Plate, and Part Description and Part Number as shown on Parts List. Figure 8 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX... - Page 16 For Repair Part Please supply: Model Number and MFG Date as shown on Repair Parts Name Plate, and Part Description and Part Number as shown on Parts List. Figure 9 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 17 5/16-18 x 2-1/4” Lg., Stainless Cap Screw 5/16-18 x 1-1/4” Lg., Stainless = Aquire standard hardware locally. = Cutter Kit = Overhaul Kit = Supplied as individual items Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 18 OVERHAUL KIT - Includes Item numbers: 8, 12, 18, 19, 20, 24, 27, 28, 29, 33, 38, 39, 40 PFG2HH-OHK Capacitor Pack for PFG2002HV / HH Panel if other than a Power-Flo panel, 200 volt, 1 phase. PF88243 Capacitor Pack for PFG2022HV / HH Panell if other than a Power-Flo panel, 230 volt, 1 phase.
-
Page 19: Troubleshooting Chart
NOTE: Power-Flo Pumps & Systems assumes no responsibility for damage or injury due to disassembly in the fi eld. Disassembly of the pumps or supplied accessories other than at Power-Flo Pumps & Systems or its authorized service centers, automatically voids warranty. -
Page 20: Limited Warranty
This warranty gives you specifi c legal rights and you may also have other rights which vary from state to state. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
Need help?
Do you have a question about the PFG2002HV and is the answer not in the manual?
Questions and answers