Table of Contents
Advertisement
Quick Links
INSTALLATION, SERVICE & PARTS MANUAL
Power Flo Pumps & Systems 877 24PUMPS www powerflopumps com
Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com
Series:
PFGPC2002HVS & HHS
PFGPC2002HVSA & HHSA
PFGPC2022HVS & HHS
PFGPC2022HVSA & HHSA
Series:
PFGPC2002HV & HH
PFGPC2022HV & HH
2 HP • 3450 RPM • 60 Hz
Submersible Grinder Pump
BACK TO INDEX
Single Seal
Double Seal
ISP No: PFGPC-Grinder - 11/09
Advertisement
Table of Contents
Related Manuals for Power-flo PFGPC2002HVS Series
Summary of Contents for Power-flo PFGPC2002HVS Series
- Page 1 Double Seal 2 HP • 3450 RPM • 60 Hz Submersible Grinder Pump Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com Power Flo Pumps & Systems 877 24PUMPS www powerflopumps com ISP No: PFGPC-Grinder - 11/09 BACK TO INDEX...
-
Page 2: General Safety Information
60 Hz 877-24 PUMPS www.powerflopumps.com ® Power-Flo is a registered trademark of Power-Flo Technologies Inc. Other brand and product names are trademarks or registered trademarks of their respective holders. Alteration Rights Reserved. 6/09, 8/09, 9/09, 11/09 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com... -
Page 3: Single Seal
2 HP • 3450 RPM • 60 Hz Submersible Grinder Pump Description Designed to reduce domestic, commercial, institutional and light industrial sewage to a fi nely ground slurry. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX... - Page 4 30 Amp internal - MARS 169 internal - 150 mfd-250v internal - 45 mfd-450v Winding resistance ± 5% at terminal block. Rated operation at ± 10% voltage at motor. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
-
Page 5: Double Seal
NOTE: Consult factory before making modifi cations as they may eff ect CSA listing. Submersible Grinder Pump Description Designed to reduce domestic, commercial, institutional and light industrial sewage to a fi nely ground slurry. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX... - Page 6 30 Amp internal - MARS 169 internal - 150 mfd-250v internal - 45 mfd-450v Winding resistance ± 5% at terminal block. Rated operation at ± 10% voltage at motor. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 7 PFGPC - HH, HHS 2HP Submersible Grinder Pumps Performance Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 8 PFGPC - HV, HVS 2HP Submersible Grinder Pumps Performance Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
-
Page 9: Receiving And Installation
5” from end nearest volute and Bottom of Feet when the level control is in the “Off ” Figure 1 oriented towards the pump body. mode. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX... -
Page 10: Installation & Service
Incorrect rotation amber in color and free from suspended for Single-Phase pumps is unlikely. particles. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX... - Page 11 (48) and assemble to intermediate screwdriver. Do Not store pump without coupling (21B). impeller in place. Lower Housing Pressure Test Figure 4 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 12 (21) along with square ring (20), replace if cut or damaged. Remove stator bolts and carefully remove stator housing Figure 5 (Double Seal Unit Shown) from rotor. Pull rotor out with bearing (18). Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 13 (24) in bottom groove of seal plate (51). Place seal plate (51) over shaft and onto intermediate coupling (21B), being sure square ring (24) is not twisted and in the groove. Figure 7 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 14 Figure 9 - 200/230 Volt, housing (19) onto motor housing (15), 1Phase with Capacitors - place cap screws (22) and lockwasher PFGPC Series (11) into housings and torque to 6.5 ft/ lbs. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
-
Page 15: Repair Parts
For Repair Part Please supply: Model Number and MFG Date as shown on Repair Parts Name Plate, and Part Description and Part Number as shown on Parts List. Figure 10 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX... - Page 16 For Repair Part Please supply: Model Number and MFG Date as shown on Repair Parts Name Plate, and Part Description and Part Number as shown on Parts List. Figure 11 Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 17 Outer Shaft Seal Carbon/Ceramic/Buna-N PF110395 Screw #8-32 = Aquire standard hardware locally. = Supplied as individual items = Cutter Kit * = Included with item #1 = Overhaul Kit Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
- Page 18 OVERHAUL KIT - (Double Seal) include: 8, 12, 13, 14, 16, 18, 20, 24, 27, 28, 29, 33, 38, 39, 40, 53 PFGPCHH-OHK = Aquire standard hardware locally. = Supplied as individual items = Cutter Kit * = Included with item #1 = Overhaul Kit Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
-
Page 19: Troubleshooting Chart
NOTE: Power-Flo Pumps & Systems assumes no responsibility for damage or injury due to disassembly in the fi eld. Disassembly of the pumps or supplied accessories other than at Power-Flo Pumps & Systems or its authorized service centers, automatically voids warranty. -
Page 20: Limited Warranty
This warranty gives you specifi c legal rights and you may also have other rights which vary from state to state. Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com BACK TO INDEX...
Need help?
Do you have a question about the PFGPC2002HVS Series and is the answer not in the manual?
Questions and answers