Example Of The Use Of The Contact Signal Circuit; Precautions And Notes For The Use Of The Contact Signal - Omron BU100RS Instruction Manual

6 Contact signal functions
6-1 Contact signal functions

6-1-7 Example of the use of the Contact Signal circuit

● Example of BU signal output circuit and
● Remote ON/OFF circuit
6-1-8 Precautions and notes for the use of the Contact
Signal
82
the connected circuit
+12V
C1
1KΩ
TLP521
*
C1,C2 : 0 pF to several
thousand pF
Inside of External
(Consider the capacity according to the
UPS Circuit operating environment.)
Example of
remote
Remote
ON/OFF ON/OFF (+)
Remote
ON/OFF (-)
UPS side
When connecting a device such as a relay that generates counter
electromotive force to the signal output circuit, connect diodes that prevent
counter electromotive force to both ends of the relay.
Explanation:
● When power is restored after the unit stopped automatically during a power failure,
the unit automatically restarts and supplies power. If you do not want to start the
connected devices, turn OFF their switches or set the auto startup setting after
recovery from power failure ("Setting" switch 2) to ON (Auto startup is not
performed).
● Example of BS signal input circuit
and the connected circuit
+5V
4.7K
To port
C2
on PC
UPS side
Connecting cable
(twisted or shielded)
Notes
12V 1K TLP521
1.2K
BS
From port on PC
C2458
COM
GND
System side
BU100RS