Service - Runco CINEWIDE VX-6000D Installation & Operation Manual

Operation

Service

Service
Test Video
Input Names
Remote Control
Display Device
Color Space
Triggers
Miscellaneous
Sync Threshold
HDMI EDID Extension
Front Panel Brightness
System Reset
Input Names
Restore
C o m p o s i t e
Composite
S - V i d e o 1
S-Video 1
S - V i d e o 2
S-Video 2
C o m p o n e n t
Component
H D 1 HD 1
H D 2
HD 2
S C A R T
SCART
H D M I 1
HDMI 1
H D M I 2
HDMI 2
• Splash Enable: When you have finished customizing the splash screen, select Splash
Enable from the Splash Configure menu. Then, select On and press ENTER.
OSD Position: To adjust the position of the OSD, select OSD Position from the
Calibration menu and press ENTER.
Press or to select "Hor." or "Ver." Then, press
➤
Use the Service menu to access advanced display configuration settings. This menu
should be used by ISF-certified technicians only.
Note
Test Video: Select Test Video from the Service Menu to access the internal test patterns
on the VX-6000d. Four patterns are available: Horizontal Ramp, Vertical Ramp,
Color Bars 1 (solid bars) and Color Bars 2 (SMPTE "checkerboard" pattern).
Press MENU to exit test pattern mode.
Input Names: You can give each DHD Controller input a descriptive name. For example,
you may want to change the default input name to the type of source component
connected to it: "VCR," "DVD," "Laptop" et cetera. Input names can be up to 12
characters long.
To edit an input name, select Input Names from the Service menu. Press
an input and press ENTER. Use the
or to select a character to change. When you have finished editing the input name,
press ENTER or MENU.
To restore the default input name, press
"Restore" column. Then, press ENTER.
You must enter a passcode to access the Service menu for the first
time after turning on the system.
or buttons to change a character; press
repeatedly to highlight that input name in the
68
or to change the position.
Runco VX-6000d Installation/Operation Manual
or to select