Runco CINEWIDE VX-6000D Installation & Operation Manual page 86

Operation
• Altitude: Select Altitude from the Display Device - Configure menu to control the
operation of the projector's cooling fan.
In most cases, the default setting (Auto) will maintain the correct operating
temperature. If the lamp frequently turns off due to overheating, or in certain
high-altitude operating environments, you may need to change this setting to High.
Color Space: Select Color Space from the Service menu to choose the color space of
the source signal for HDMI, RGB, and component connections.
• The default setting, Auto, functions as follows:
• HDMI: If the Auxiliary Video Information (AVI) infoframe contains color space and/or
range data, the VX-6000d uses that information. Otherwise, for RGB sources, the
VX-6000d uses the RGB-Video color space. For component SDTV and EDTV
resolutions, REC601 is used. For other component video resolutions, REC709 is
used.
• RGB: If Hsync or Vsync signals are present, the VX-6000d uses the RGB-PC color
space. Otherwise, REC601 is used for SDTV and EDTV sources, and REC709 for
all other sources.
• Component: For SDTV and EDTV resolutions, the VX-6000d uses the REC601
color space. For all other resolutions, REC709 is used.
In most cases, the Auto setting determines the correct color space to use. If it does not,
you can force the VX-6000d to use a specific color space. Choose one of the following:
• REC709 sets the color space matrix to that defined in ITU-R BT.709.
• REC601 sets the color space matrix to that defined in ITU-R BT.601.
• RGB-PC uses RGB color space and sets black at 0,0,0 RGB and white at
255,255,255 RGB, assuming an 8-bit image.
• RGB-Video uses RGB color space and sets black at 16,16,16 RGB and white at
235,235,235, assuming an 8-bit image, to correspond to the luminance values defined
in digital component standards.
Triggers: Select Triggers from the Service menu to configure the 12-volt trigger outputs.
You can assign one or more trigger outputs to each aspect ratio. Those triggers are then
activated by selecting that aspect ratio.
If you are using the VX-6000d with a projector is equipped with the Runco CineWide with
AutoScope system, assign at least one trigger output (the same one to which the lens
motor is connected) to the Cinema and Virtual Cinema aspect ratios.
70 Runco VX-6000d Installation/Operation Manual