Connecting To Ac Power; Turning On The Power - Runco CINEWIDE VX-6000D Installation & Operation Manual

Installation

Connecting to AC Power

3.7

Turning on the Power

➤
Projector/DHD Controller: The VX-6000d system includes two (2) AC power cords
(one each for the projector and DHD Controller).
Plug the female end of one power cord into the AC receptacle on the rear of the
VX-6000d (AC 100V ~ 240V). Then, connect the other end to your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, a third power cord is
provided for the lens motor. Plug the female end of the AC power cord into the AC input
on the rear of the lens motor assembly. Connect the other end to a 110 VAC power
source.
Caution
1. Turn on your source components.
2. Turn on the main power switch at the rear of the DHD Controller.
3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input (see Figure 3-17).
4. Press the ON button on the remote control – or the ON/STANDBY (
the DHD Controller front panel – to turn on the system. The vacuum fluorescent
display on the DHD Controller front panel briefly displays "Initializing System," followed
by "Starting VX-2000/6000."
5. When the projector has completed its initialization and is ready for use, the fluorescent
display on the DHD Controller indicates the active source, input resolution/frame rate
and aspect ratio; for example:
VX2000/6000
16:9
Aspect Ratio
The input voltage to the AutoScope lens motor must be between
100 and 120 VAC. Do not connect the AutoScope lens motor
to a 200-240 VAC power source!
Input Resolution/Frame Rate
42
Current
Source
HDMI 1
1080i/60
Runco VX-6000d Installation/Operation Manual
) button on