Installing And Adjusting The Cinewide Anamorphic Lens; Remove The Projector Front Jewelry; Installing The Anamorphic Lens; Anamorphic Lens Mounting Assembly - Exploded View - Runco Reflection CL-610 CineWide Owner's Operating Manual

Installation
3.10
Installing and
Adjusting the
CineWide Anamorphic
Lens
Remove the Projector
Front Jewelry
Installing the Anamorphic
Lens
If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
It is extremely important that the primary lens is properly
Note
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
The Anamorphic lens mount kit consists of everything shown in Figure 3-10. If any items
are missing or damaged, please contact your Runco dealer or Runco Customer Service at
(800) 23RUNCO.
Figure 3-10. Anamorphic Lens Mounting Assembly - Exploded View
Loosen the small Phillips screw (directly below the lens) holding the jewelry in place. Then,
remove the jewelry.
1. Use the Pitch Adjustment Screws (item #3) and Washers (item #6) to attach the
Mounting Brackets (item #2) to the Anamorphic Lens (item #1). (Do not fully tighten
the screws yet.)
2. Use the four Y-Adjustment Screws (item #5) and Washers (item #4) to attach the
Anamorphic Lens assembly to the front of the projector. (Again, do not fully tighten
the screws yet.)
1 Anamorphic Lens
26 Runco CL-610 Series Owner's Operating Manual
2 Mounting Bracket (2x)
3 Pitch Adjustment Screw,
4-40 x 5/16" (4x)
4 Washer (4x)
5 Y-Adjustment Screw,
Phillips Pan-Head,
6-32 x 3/8" (4x)
6 Fender Washer (4x)