Runco Reflection CL-610 CineWide Owner's Operating Manual page 56

Operation
Video Black Level: This control compensates for incoming elevated black levels present
in certain video signals, and ensures that blacks in the display are neither "crushed"
(where dark grays appear black) nor excessively elevated (where blacks appear dark
gray). By default, the projector automatically determines the best setting according to the
type of incoming video signal:
• 0 IRE: Used for DVD output with "enhanced black," SECAM, most PAL standards and
Japanese NTSC.
• 7.5 IRE: Used for most NTSC video signals.
For some types of video, you may want to override the setting. Generally, if black appears
crushed when brightness = 30, choose "0 IRE." If black appears excessively elevated, use
"7.5 IRE."
Lamp Power: Select Lamp Power from the Set Up Menu to adjust the lamp output level.
You can choose to run the lamp as bright as possible (250W; this is the default setting) or
you can choose the lower (200W) setting. Generally, lower lamp output can prolong the
life of the lamp, but decreases brightness.
Remote Control: The Remote Control menu shows you the primary and secondary
infrared (IR) codes to which the CL-610 will respond. The Primary IR code is permanently
set to +20. The secondary IR code is also +20.
You can change the secondary IR code if either:
• Another device in the theater (a DVD player, for example) is responding to commands
from the CL-810 remote control in ways that are unpredictable or undesirable.
• You have multiple CL-610 projectors and want to control them independently, as
opposed to broadcasting commands from a single remote to all of them. In this
scenario, you can use multiple remotes programmed to use different IR codes. Or, you
can use a single remote and change the IR code as needed to address a specific
projector.
When you change the secondary IR code, the remote sends that code instead of the
primary IR code.
The Remote Control menu is read-only and need not be visible in
Note
order to change the secondary IR code.
To simultaneously change the secondary IR code and synchronize that remote with a
projector, point the remote at the projector, then press and hold
for five seconds. The Remote Control edit window, shown at right, appears. Type a new,
two-digit code.
The procedure for changing the secondary IR code on the remote only is the same,
except that you point the remote away from the projector.
44 Runco CL-610 Series Owner's Operating Manual
and simultaneously