Installing And Adjusting The Cinewide Anamorphic Lens; Anamorphic Lens Mounting Assembly - Exploded View - Runco Quantum Color Q-750i Series Installation & Operation Manual

Installation
3.12
Installing and
Adjusting the
CineWide Anamorphic
Lens
If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
It is extremely important that the primary lens is properly
Note
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
The Anamorphic lens mount kit consists of everything shown in Figure 3-17. Some
components shipped with your projector may differ slightly from what is shown in these
instructions.
1
Anamorphic Lens
10
Set Screw
9
Pitch Adjustment
T-Nut (2x)
Yaw/X Adjustment
8
Lever (2x)
Figure 3-17. Anamorphic Lens Mounting Assembly - Exploded View
Lens Adapter Ring and
Mounting Screws (3x)
38
2
Pitch Adjustment Yoke for Lens
3
Height/Y Adjustment
T-Screw and Washer
(2x)
4
5
Anamorphic Lens
Holder
6 1/4-20 Hex Bolt (2x)
and Washer (2x)
7
AutoScope Carriage Plate or
Fixed CineWide Base Plate
Q-750i Series Installation/Operation Manual
Pitch Adjustment
T-Screw and
Washer (2x)