Installing The Projection Lens - Runco Video Xtreme VX-44d Owner's Operating Manual

The projection lens is shipped separately from the projector. Proceed as follows to install
the projection lens:
1. Remove the lens plug from the lens opening in the projector.
2. Place the lens cap on the projection lens to protect it from being damaged during the
installation process.
3. Remove the rear cap from the lens. This protective cap is only used during shipping to
protect the lens from damage.
4. Slide the new lens into the lens opening of the projector. Make sure to align the
connector on the side of the lens with the connector assembly on the lens retaining
ring; see Figure 3-6.
As you connect the lens, you may have to re-align it slightly until the tabs on the lens
fit into the slots in the lens retaining ring.
Figure 3-6. Lens Assembly (Front View)
5. With the lens fully inserted (and connected), turn it clockwise until the lens release
button "pops" indicating the lens is fully inserted.
Runco VX-44d/-55d Owner's Operating Manual 25
Installation
3.4
Installing the
Projection Lens