Table of Contents
Advertisement
The Q-750i primary projection lens is shipped separately from the projector. Proceed as
follows to install it:
1. Carefully remove the projector from the
shipping container and place it on a flat
surface.
2. Loosen the Phillips screw at the bottom of
the decorative bezel on the front of the
projector.
3. Grasp the bezel by the front, then rotate and lift it upward to remove it. (Don't pull it
straight out.)
4. Remove the foam plug from the lens cavity.
Q-750i Series Installation/Operation Manual
19
Installation
3.4
Installing the Primary
Projection Lens
(Q-750i Ultra only)
Advertisement
Table of Contents
