Runco Video Xtreme VX-44d Owner's Operating Manual page 86

Operation
Service
Service
Test Video
Input Names
Remote Control
Analog Out Mode
Display Device
HD Format
Triggers
Miscellaneous
Resolution
System Reset
Restore Saved Settings
Input Names
Restore
Composite Composite
S-Video 1 S-Video 1
S-Video 2 S-Video 2
Component SD Component SD
HD/RGB 1 HD/RGB 1
HD/RGB 2 HD/RGB 2
HDMI 1 HDMI 1
HDMI 2 HDMI 2
Save
➤
Use the Service menu to access advanced projector configuration settings. This menu
should be used by ISF-certified technicians only.
Note
Test Video: Select Test Video from the Service Menu to access the internal test patterns
on the VX-44d/-55d. Four patterns are available, consisting of white/gray or colored bars.
Press MENU to exit test pattern mode.
Input Names: You can give each DHD Controller input a descriptive name. For example,
you may want to change the default input name to the type of source component
connected to it: "VCR," "DVD," "Laptop" et cetera. Composite, S-Video and Component
SD input names can be up to 12 characters long; the others can be up to eight characters
long.
To edit an input name, select Input Names from the Service menu. Press
an input and press ENTER. Use the
to select a character to change. When you have finished editing the input name, press
MENU.
To restore the default input name, press
"Restore" column. Then, press ENTER.
To save input names so that they can be restored after a System Reset (described on
page 77), press
Note
Remote Control: The Remote Control menu shows you the primary and secondary
infrared (IR) codes to which the DHD Controller will respond. By default, both are set to
17. You can change these codes if either:
• Another device in the theater (a DVD player, for example) is responding to commands
from the DHD Controller remote control (Figure 2-6) in ways that are unpredictable or
undesirable.
• You have multiple DHD Controllers and want to control them independently, as
opposed to broadcasting commands from a single remote to all of them. In this
scenario, you can use multiple remotes programmed to use different IR codes. Or, you
can use a single remote and change the IR code as needed to address a specific
device.
Tip
You must enter a passcode to access the Service menu.
or
repeatedly to highlight "Save." Then, press ENTER.
The button takes you from top to bottom in the left column, then
from top to bottom in the right column. To highlight "Save," scroll
through both columns.
Use the DHD Controller front-panel keypad to change its IR code.
Then, change the code sent by the remote to match as described
below.
74
buttons to change a character; press
repeatedly to highlight that input name in the
Runco VX-44d/-55d Owner's Operating Manual
or to select
or