Table of Contents
Advertisement
13) How do you reset the SPM-200?
• The IP Reset Button, located under the RJ45 connector, has two functions:
1) If you hold it down while you power up the unit, all of the user-configurable parameters are reset to the
factory defaults.
2) If you hold it down for 20 seconds while the power is on, it resets the IP address to 192.168.1.123 and the
subnet mask to 255.255.255.0, and clears out any user IDs and Passwords that you have set. This is useful
if you have forgotten the IP address you set. See Troubleshooting 4 for more information.
14) Information not saved
• "Form data not saved" will be visible at the top of the page, this indicates that information was not
formatted correctly or missing. Verify that all information is inputed and formatted correctly and
click save.
15) Cannot change passwords
• Admin user name and password must be entered to change any user name and password.
16) Admin information will not save
• Both e-mail and phone number must be valid and entered. (me@spm.com, 123-456-7890). Phone number
can only contain numbers and dashes.
17) Friendly names do not show up in drop down list
• Incompatible browser. Use different browser or use default alarm names in drop down list.
15272 Newsboy Circle
Huntington Beach
California 92649
www.newmartelecom.com
Phone: 714-751-0488
Fax: 714-896-9679
E-Mail: techservice@newmarpower.com
27
Advertisement
Table of Contents
