Setting Low & High Alarm Trips; Cameras Page - NewMar SPM-200 Installation & Operation Manual

Site power monitor
Hide thumbs Also See for SPM-200:
Table of Contents

Advertisement

5.1 Setting Low & High Alarm Trips
The Alarms web page is where you configure the alarms for the unit.
FIGURE 9: Alarms Page
The user selects which data item each alarm covers. In the example above, Alarm #01 is set to trip if the
("Volts DC 1" input goes above 30.0V). We know it will trip if the value goes above the set point because "High
Trip" has been selected. Note Alarm #02 is set to trip if the (same input goes below 22.0V {"Low Trip")}. Any
number of alarms can be set on each input value, as long as the total number of alarms is less than 20.
Note how Input Select is pulled down for Alarm #03. This illustrates how the user can select any input for any
given alarm.
When Alarm #01 is tripped it will send emails to the first two email addresses, and both SNMP traps will be
triggered. (We'll see how to set the email addresses and SNMP traps on the Configuration Page later). Each
alarm can send emails to any combination of the 5 email addresses and 2 SNMP traps. It is common to set
one alarm to send an email to one or more email addresses if an input value exceeds a first threshold, and
set a second alarm to send emails to different address(es) if the same input value exceeds a second threshold.
This allows an escalation procedure to be set up.
If you make changes to this (and any other web page on the SPM-200) don't forget to click "Save" when you're
finished. If you don't, your changes will be lost.
The Logging page graphs selected data over a selected time range, and controls data logging in general.
- VOLTS DC 3 Note: Alarm Low & High Trip are opposite of conventional thinking. For example, when setting a
'Low Trip' on a 48 volt battery, select 'High Trip' for -42.0 trip point.

5.2 Cameras Page

This is the web page that displays the camera images which can be set up by going to the 'Config' >
'Cameras'. Click on 'Update Cameras' button to refresh images.
15272 Newsboy Circle
Huntington Beach
California 92649
www.newmartelecom.com
Phone: 714-751-0488
Fax: 714-896-9679
E-Mail: techservice@newmarpower.com
14

Advertisement

Table of Contents
loading

Table of Contents