Table of Contents
Advertisement
4.1.3 Setting the Clock
This section covers setting the clock and confi guring your SPM to connect over a network. NOTE: If you don't
have a network to connect to, the SPM-200 can be used as a simple data logger with a Web interface. The
only item that you must set is the clock, as described below. To set the clock, place cursor over 'confi g' and
select "System Clocks' from the drop down menu.
FIGURE 6: Setting the Clock
Select "Manual –GMT" in the "Set Clock Method" pulldown. Enter the date and time in the appropriate boxes.
The box asks for the time in GMT, and the offset from GMT for your local area. That is not necessary if you are
setting the clock manually. Just set the local date and time and put "0:00" as the GMT to local offset. Be sure to
click "Save" when you are done. The date and time should then be displayed at the top of each page, and the
SPM will begin logging data.
Note: The SPM will not adjust for Daylight Savings Time; you have to do that manually.
It is also possible for the SPM to determine the correct time from an NTP server if one is available. Since the
SPM is not connected to a real network that won't work now.
15272 Newsboy Circle
Huntington Beach
California 92649
www.newmartelecom.com
Phone: 714-751-0488
Fax: 714-896-9679
E-Mail: techservice@newmarpower.com
11
Advertisement
Table of Contents
