Table of Contents
Advertisement
FIGURE 20: Networking Section of the Config Webpage
Enter the appropriate IP address, Subnet Mask and Gateway address. CAUTION: once you click "Save",
the SPM will IMMEDIATELY switch to the IP address you just entered. It will NOT respond at 192.168.1.123
anymore. See 8.0 Appendix A: Troubleshooting #13 which describes the "Reset" button to function and use.
If you are sure you have the correct settings, go ahead and click the "Save Changes" button. Now you will
have to disconnect the SPM from the PC and the crossover cable, and connect it to your real network. You
should be able to access it by opening a browser window and entering the new address that you just set.
Note: Cross over cable cannot be used to connect to routers.
FIGURE 20: Syslog Configuration
15272 Newsboy Circle
Huntington Beach
California 92649
www.newmartelecom.com
Phone: 714-751-0488
Fax: 714-896-9679
E-Mail: techservice@newmarpower.com
22
Advertisement
Table of Contents
