Stack Light Option; Base Height Adjustment - Advanced Poly-Packaging T-1000-S14 Advanced Poly-Bagger Operation Manual

Fill Time> is the amount of time, in seconds, that an output will be sent to an auxiliary piece of equipment,
after the bag has been opened and the opening validated. A typical value is .2 seconds.
<DownDelay> is a delay time before the finger will attempt to enter the bag, after it is initially blown open.
A typical value is .5 seconds.
<CloseDelay> is the amount of time, in seconds, after the fingers have entered the bag, before the fingers
will pull the bag to the gripper point. A typical value is .4 seconds.
<Open> Cycle button allows you to test cycle the Bag Opening Device alone, without initiating other
equipment or the T-1000 seal operation.
A Help Screen for the Bag Opener Operation is provided for information.
Note: Valve # X indicates the Valve Station number assigned to this option. Valve #0 indicates that no
valve is assigned to this option. The option will not operate unless a Valve Station number is assigned,
other than 0.
3.38 ST-10 Stack Light Option
The ST-10 Stack Light option is not included in the standard T-1000 package and must be purchased
separately. This option consists of a two or three LED options. Two LED indicates on Operation
Condition (Green) or a Stop/Fault Condition (Red). Three LED indicates the same as the two LED option,
but adds a Warning condition (Yellow) which can be used for low materials or other warnings within a
system.

3.39 Base Height Adjustment

An option that allows the T-1000 Bagger to be conveniently versatile is the "Base Height Adjustment"
Option, which allows the operator to raise or lower the base of the bagger, which is necessary particularly
when other equipment, such as conveyors is to "work" with the Ti-1000 See Figure 3-55.
To adjust the base of the bagger, select the "Height Adjustment" button from the Option Menu an turn it
"ON". To raise the bagger select "JOG UP", to lower the bagger select "JOG DOWN".
See Figure 3-56.
3.40 UF-5000 Infeed Conveyor Operation Screen
The T-1000 is programmed to also control the UF-5000 Infeed Conveyor. This screen allows the operator
to setup the conveyor to run standalone, with the T-1000 or with parts counters. See Figure 3-57.
CONV CYCLE button manually cycles the conveyor and also toggles OFF auxiliary mode buttons and
bagger Run buttons.
SETUP/RUN button toggles ON the conveyor to operate with the T-1000.
ON/OFF Bagger Auxiliary button sets up the communication with T-1000.
ON/OFF Counter Auxiliary button sets up the communication with counters (UC-2400).
PART SENSOR turns on photo eyes mounted in the discharge funnel of the UF-5000 (CE-10) option, if
equipped.
46 46