Memory Backup
Your receiver continually saves any settings you have made even if power is lost. However, you may wish to save
a backup of your settings in case of inadvertent changes to them. To perform a backup follow the procedure
below. To restore backup settings perform the same procedure but select restore instead of backup. If you have
never made a backup, then performing a restore will call back the original factory settings.
1 Help / Navigate
2 Product Information
3 Zone 2 Operation
4 Edit Preset
5 User Preferences
6 Setup / Configure
SEL
M E N U
From Remote
V
1
(PAUSE) or
(STOP)
2
SEL or ENTER
USER PREFERENCE SETUP
1 Edit Preset Options
2 Edit Source Names
3 Display Setup
4 Surround Modes
5 Memory Options
SEL
M E N U
From Remote
V
1
(PAUSE) or
(STOP)
2
SEL or ENTER
3
(REW) or (FF)
4
SEL or ENTER
5
MENU
6
MENU
7
MENU
MAIN MENU
move to new line
select menu page
exit menu system
From Front Panel
(UP) or
(DOWN)
(ENTER)
move to new line
select menu page
previous page
From Front Panel
(UP) or
(ENTER)
VOLUME KNOB
(ENTER)
MENU
MENU
MENU
USER PREFERENCE SETUP
1 Edit Preset Options
2 Edit Source Name
3 Display Setup
4 Surround Modes
5 Memory Options
move to new line
SEL
select menu page
M E N U
previous page
Action
move to User Preferences
activate USER PREFERENCE SETUP
MEMORY BACKUP AND RESTORE
1 Memory Operation Backup
Save ALL memory
settings in EEPROM
SEL
perform operation
adjust parameter
M E N U
previous page
Action
move to Memory Options
(DOWN)
activate MEMORY BACKUP AND
RESTORE
choose Backup or Restore
perform Backup or Restore
return to USER PREFERENCE
SETUP
return to MAIN MENU
return to normal operation
31
p/n 12699 Rev. 9812C