MEMORY BACKUP
Your receiver continually saves any settings you have made even if power is lost. However, you may wish to
save a backup of your settings in case of inadvertent changes to them. To perform a backup follow the procedure
below. To restore backup settings perform the same procedure but select restore instead of backup. If you have
never made a backup, then performing a restore will call back the original factory settings. Make sure you are in
the MAIN MENU and your remote is in B&K mode.
MAIN MENU
1 Zone 1 Operation
2 Zone 2 Operation
3 Zone 1 Favorite Presets
4 Zone 2 Favorite Presets
5 System Setup
6 Memory Backup/Restore
6 Memory Backup/Restore
next item
MENU
BACKUP/RESTORE
From Remote
1
À(PAUSE) or §(STOP)
2
SEL or ENTER
¶
•
3
(REW) or
(FF)
4
SEL or ENTER
5
MENU
6
MENU
SEL select
exit menu system
From Front Panel
. (UP) or - (DOWN)
↵ (ENTER)
VOLUME KNOB
↵ (ENTER)
∠ MENU
∠ MENU
MEMORY BACKUP AND RESTORE
1 Memory Operation Backup
1 Memory Operation Backup
Save ALL memory
settings in EEPROM
SEL perform
MENU main menu
MEMORY BACKUP
Action
move to Memory Backup/Restore
activate MEMORY BACKUP AND RESTORE
choose Backup or Restore
perform Backup or Restore
return to MAIN MENU
return to normal operation
45
adjust
13259 0303