Choosing A Source; Tuner Operation - B&K AVR101 Series Owner's Manual

CHOOSING A SOURCE

In general, the selected source will appear at the ZONE 1 output, the TAPE output, and the V1 output. To prevent
feedback, TAPE input will not appear at TAPE output and V1 input will not appear at V1 output.
DVD Source
DVD PCM 2.0
From Remote From Front Panel
desired source
AUDIO
Note: if your source has separate ON and OFF control like your receiver, pressing the source button will also turn
on that source. If not, you will have to hit POWER while the remote is still set to the desired source.
TAPE MONITOR - If you have an analog three-head cassette or reel-to-reel analog tape recorder you may wish to
use TAPE MONITOR, which allows you to hear exactly what is on the tape as you are recording.
Tape Source
Analog 2.0
From Remote From Front Panel
desired source
TAPE
Note: The tape monitor loop only allows recording of analog inputs. If you simply choose the source you wish to
tape without then selecting TAPE MONITOR then you can make analog recordings of digital inputs as well as
analog inputs.

TUNER OPERATION

FM St 96.9
Ch 0
From Remote
1 AUDIO
2 TUNER
3 BAND
4
CHAN or CHAN
5 TUNE+ or TUNE-
6 SEL or ENTER
Note: For a few seconds after performing any tuner operation (
directly enter a frequency from the remote control's numeric keypad. During this time the front panel VOLUME
KNOB also controls frequency and
Composite Video
Pro Logic
(SOURCE) step to source
S-Video
Pro Logic
(SOURCE) step to source
(SOURCE) step quickly to TAPE
Composite Video
Pro Logic
From Front Panel
U
(SOURCE) step to AM or FM
(UP) or (DOWN)
(UP) or (DOWN) and then
VOLUME KNOB
(ENTER)
controls stereo/mono selection.
SEL or ENTER
Action
select desired source - remote now controls source
return control to receiver if desired
Action
select desired source or TUNER
source will appear on TAPE and V1 outs
wait a few seconds while receiver analyzes
selected source
select TAPE monitor
TAPE will appear on Z1 out
Action
make sure remote is in AUDIO mode
select TUNER
select AM or FM
change to another channel
manually tune up or down to desired frequency
see AM/FM TUNER SETTING for DIRECT / SEEK / TUNE
set FM stereo/mono
,
TUNER BAND
33
, , or ) you may
CHAN TUNE+/-
p/n 12699 Rev. 9812C