Zone Configuration; Z1 Setup - B&K AVR101 Series Owner's Manual

ZONE CONFIGURATION

Zone Configuration will allow you to set maximum volume levels for each zone, change remote control ID codes
for each zone and turn off the on-screen display overlays in zone 1. Make sure you are in the ADVANCED
SYSTEM SETUP menu and the remote is in AUDIO mode.

Z1 Setup

Z1 Max Level - Z1 max level allows you to set a maximum volume level for zone 1. This is very useful if you are
using speakers that can't handle the maximum power output from your receiver or if you simply wish to limit the
volume that can be achieved using normal front panel or remote operation.
WARNING - If you set this level too low, the receiver may appear broken (no sound).
ADVANCED SYSTEM SETUP
1 Zone 1 Setup
2 Zone 2 Setup
3 Power On Titles
4 Control Out
5 Security Options
From Remote
­ V
1
(PAUSE) or (STOP)
2 SEL or ENTER
­ V
3
(PAUSE) or (STOP)
4
(REW) or (FF)
Z1 Product ID - Each message transmitted from your remote includes a Product Code, identifying the
manufacturer, and a product ID code from 1 to 16. The product ID code allows multiple B&K products to be
controlled from the same remote. Your receiver actually uses two product ID codes - one for zone 1 (normally set
to ID code 1) and the other for zone 2 (normally set to ID code 2). If you have a system with multiple B&K products
then you may wish to set the product ID codes to other values. Note that you cannot set the Z1 product ID to the
same setting as zone 2 or vice versa. If you need to set zone 1 to the current zone 2 setting then set zone 2 to
some other value first. Make sure you are in the ADVANCED ZONE SETTINGS menu and the remote is in AUDIO
mode.
WARNING - if you change the product ID code in the receiver without making the corresponding change
to the remote then the remote will no longer work. Refer to the separate remote manual for details on
changing the remote's product ID ("device code").
move to new line
SEL select menu page
M E N U previous page
From Front Panel
(UP) or
(ENTER)
(UP) or
VOLUME KNOB
ADVANCED ZONE 1 SETTINGS
1 Z1 Max Level
2 Z1 Product ID
3 Z1 On Screen
4 V1 Output
WARNING Connecting a tape
recorder to V1 in LINE mode
can cause speaker damage
M E N U
ADVANCED ZONE 1 SETTINGS
1 Z1 Max Level
2 Z1 Product ID
3 Z1 On Screen
4 V1 Output
WARNING Connecting a tape
recorder to V1 in LINE mode
can cause speaker damage
move to new line
adjust parameter
M E N U previous page
Action
move to Zone Configuration
(DOWN)
activate ADVANCED ZONE SETTINGS
move to Z1 Max Level
(DOWN)
set desired maximum level
+15 dB
1
Enabled
Tape
move to new line
adjust parameter
previous page
42
+15 dB
1
Enabled
Tape
p/n 12699 Rev. 9812C