Mitsubishi Electric MELSEC iQ-RD77MS2 User Manual page 93

Serial absolute synchronous encoder cable
Generally use the serial absolute synchronous encoder cables available as our products. If the required length is not found in
our products, fabricate the cable by a customer side.
■Selection
The following table indicates the serial absolute synchronous encoder cables used with the serial absolute synchronous
encoder. Connector sets (MR-J3CN2) are also available for your fabrication.
Cable model
Q170ENCCBL_M-A
Use the following or equivalent twisted pair cables as the serial absolute synchronous encoder cables.
Connector sets type
MR-J3CN2
Wire model Core size
2
[mm ]
J14B103715-00 12 pairs 0.2
(BLACK)
*1 d is as shown below.
d
Conductor Insulation sheath
*2 Standard OD (Outside Diameter). Maximum OD is about 10% larger.
CAUTION
• When fabricating the encoder cable, do not make incorrect connection. Wrong connection will cause runaway or explosion.
Cable length [m (ft.)]
2 (6.56), 5 (16.40), 10 (32.81), 20 (65.62),
30 (98.43), 50 (164.04)
Description
Servo amplifier connector
Number Characteristics of one core
of cores
Structure
[Number of wires/
mm]
24 (12 pairs) 40/0.08
Wire model
J14B103715-00 12 pairs (BLACK)
Conductor Insulating sheath OD
*1
resistance [/km] d [mm]
105 or less 0.88
Appendix 1 Component List of the RD77MS
Finished
*2
OD [mm]
9.0
A
APPX
91