ASSEMBLY INSTRUCTIONS
Tools Required:
1. Ratchet handle
2. 9/16" deep socket
3. 9/16" wrench
4. 3/4" socket or wrench
5. 7/32" allen wrench
6. Phillips head screwdriver
7. 1/2" concrete drill bit
Gasket Installation:
•
Gasket material has been applied at the factory for use at the connections/joints of the slide sections.
Additional gasket material has been supplied in case any gasket has fallen off during shipping.
•
Apply gasket in the required locations as shown in the figures below.
•
Place gasket along the section to determine the length needed.
•
Cut gasket to appropriate length.
•
Remove backing and adhere gasket to slide.
.5" TALL X .5" WIDE GASKET (18)
8. 1/4" drill bit
9. Power drill
10. PVC pipe primer & glue
11. Anti-seize
12. Saw to cut PVC pipe
13. Knife
14. Level
.25" TALL X .375" WIDE GASKET (19)
.5" TALL X .5" WIDE GASKET (18)
FIG 3: RUNWAY EXIT SECTION
4
FIG 2: RUNWAY ENTRANCE