Control Of Roller Pressure - Royal Sovereign 1050 Owner's Manual

TAKE UP DEVICE
PAPER BACK
HOT ROLLER
PAPER BACK
RSH-1050/1650
1. Set up cold film below the upper bar of the machine
(Set the same as method of HOT film for protect paper of lower part)
2. Set the pressure Lever to the 15mm, open mode
3. Insert a piece of wide cardboard (guiding paper/carrier) between the rollers
4. Pull the film from the upper roller passing over the upper idle bar to the upper
roller and put it on the upper roller.
5. Put the paper back of the film to the bobbin at take-up bar to rewind
the paper back.
6. Allow some of the film with melted resin to stick to the Guiding Paper.
7. Place the film from lower shaft beneath the film from the upper roller which is
already melting and unwind films of both rollers 30~40Cm(1~1.3ft) for loosing
the tension.
8. Set the pressure Lever to the 1mm
9. Set speed at 1 and press Run button. The films will be fed into the machine and
will come out from the rear site of machine
10. Check the status of lamination and place the pressure lever at lamination mode

CONTROL OF ROLLER PRESSURE

COLD FILM
UPPER IDLE BAR
LOWER IDLE BAR
- 11 -
TAKE UP DEVICE
PAPER BACK
HOT METAL ROLLER
PAPER BACK
RSR-685/1050
COLD FILM
UPPER IDLE BAR
ROLLER
LOWER IDLE BAR