Installation - HIKVISION DS-2CE16H0T-ITF User Manual

1.2.3 Overview of Type III Camera
Mounting Base
Pan Adjusting Screw
Tilt Adjusting Screw
Bubble
Figure 1-3 Overview of Type III Camera
Note:
Press and hold the switch button for 5 seconds to
switch the video output. Four kinds of video outputs
are available: TVI, AHD, CVI, and CVBS.

2 Installation

Before you start:
Make sure that the device in the package is in good

condition and all the assembly parts are included.
Make sure that all the related equipment is power-off

during the installation.
Check the specification of the products for the

installation environment.
Check whether the power supply is matched with

your power output to avoid the damage.
Make sure the wall is strong enough to withstand

three times the weight of the camera and the mount.
If the wall is cement, insert expansion bolts before

installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact

your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of Type I Camera
2.1.1 Ceiling/Wall Mounting without Junction Box
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill the screw holes, and the cable hole (optional)
in the ceiling/wall according to the drill template.
Cable
Hole
Side Opening
Figure 2-1 Drill Template
Power Cord
12 VDC
Switch Button
IR LED
Photoresistor
Black Liner
Safty Rope
Screw
Hole
Template
Video Cable