Advertisement
1
• Locate four (4) support legs and four (4) casters.
• Insert casters into the bottom of the support leg and push caster in
until you hear it "clicks" into place.
• Pull on the caster to assure it is properly locked in place.
• Repeat for other three (3) support legs and casters.
Support Leg Insert
2
• Locate the top rail frame.
• Lay the top rail frame on the floor with the support leg inserts facing up.
3
• Locate the four (4) support legs.
• Identify support legs labeled "A" and "B".
• Align leg "A" with leg support insert "A".
• Insert the support leg into the support leg insert and push the leg down
until you hear it "click" into the locked position.
• Repeat for other support leg "A" and two support legs "B".
Customer Service
Tel. (800) 377-3777
Bassinet Assembly
4
• Make sure all plastic mattress board supports are facing inward.
• Confirm that all four support legs have been properly inserted into the
support leg inserts as shown above.
• Pull upon all support legs to assure they are properly locked to the top
frame.
5
• Locate the mattress board and eight (8) M4 screws.
• Place the mattress board into the frame lining up the four through
holes with the plastic mattress board support nuts.
• Using a screw driver and four (4) M4 screws, tighten the
mattress board onto the plastic mattress board supports.
• Repeat this procedure for the four (4) remaining screw holes.
4
Plastic mattress
board supports
Mattress Board
www.DeltaChildrensProducts.com
Advertisement
