Appendix A Networking Connection; Switch's Rj-45 Pin Assignments - Planet FGSW-1820RS User Manual

Some stations cannot talk to other stations located on
The other port
Solution:
Please check the VLAN settings, trunk settings, or port enabled / disabled status.
Performance is bad
Solution:
Check the full duplex status of the Ethernet Switch. If the Ethernet Switch is set to full
duplex and the partner is set to half duplex, then the performance will be poor. Please
also check the in/out rate of the port.
Why the Switch doesn't connect to the network
Solution:
Check the LNK/ACT LED on the switch
Try another port on the Switch
Make sure the cable is installed properly
Make sure the cable is the right type
Turn off the power. After a while, turn on power again

APPENDIX A NETWORKING CONNECTION

A.1 Switch's RJ-45 Pin Assignments
1000Mbps, 1000Base-T
Contact
1
2
3
4
5
6
7
8
MDI
BI_DA+
BI_DA-
BI_DB+
BI_DC+
BI_DC-
BI_DB-
BI_DD+
BI_DD-
MDI-X
BI_DB+
BI_DB-
BI_DA+
BI_DD+
BI_DD-
BI_DA-
BI_DC+
BI_DC-
31