Video Streaming - urmet domus UFO 4K 1093/185FE User Manual

Type: Network connection mode: DHCP (Automatically Acquired), Static (Manual Configuration) and PPPOE; DHCP
(Automatically Acquired) is the default setting.
Client Port: The port for the clients that connect to the IP camera.
HTTP Port: Web port for the IP camera.
IP address: The IP address of the IP camera.
Subnet mask: The subnet mask of the IP camera.
Gateway: The default gateway of the device.
DNS 1: Sets the primary DNS server.
DNS 2: Sets the secondary DNS server.
UPNP: Enables or disables the UPNP function for the device (enabled by default).
Note: To enable the UPNP function, the client port must be set between 1024 and 65535; the client port is used to connect
with a cell phone or other devices.
10.3.2

VIDEO STREAMING

Select Video Streaming Setting in the Network menu to open the following page:
The following bit streams are available by default: Main bit stream, Sub stream (secondary bit stream) and Mobile
stream (cell phone bit stream).
You can set the resolution, frequency, video encoding, encoding level, bitrate control, bitrate mode, bitrate frequency,
audio, single frame interval, respectively, for the main bit stream , the secondary bit stream and the mobile stream.
Resolution: Sets the resolutions for the respective bit streams: The maximum resolution for the main bit stream is
1098x1080. The maximum resolution for the secondary bit stream is 746x576. The resolutions for mobile devices are
640x480, 320×480.
FPS: When the refresh rate is 50Hz, the maximum available FPS is 25 fps. When the refresh rate is 60Hz, the maximum
available FPS is 30 fps.
Video Code Type: Sets the video encoding (H265/H264) for each bit stream.
Video Code Level:
Bitrate control: Set constant or variable bitrate for the stream.
(Bitrate mode): User-defined or Predefined.
Note: The range of the main bit stream is 256-8192.
The range of the substream is 128-4096.
40
DS1093-582