Commands And Guidelines - Juniper E320 Configuration Manual

Junose internet software for e-series routing platforms
Hide thumbs Also See for E320:
Table of Contents

Advertisement

3. Configure the secure L2TP policy that forwards the mirrored traffic to the
4. Configure packet mirroring for the subscriber identified by username
5. Verify the packet mirroring configuration.
host1#show mirror subscribers
Subscriber ID
------------------
lac:jwbooth@isptheatre.com
6. Verify the configuration of the secure L2TP policy.
host1#show secure policy-list name l2tp_toMirrorHQ
Secure L2TP Policy l2tp_toMirrorHQ
analyzer-udp-port 6500 mirror-id 1 session-id 1

Commands and Guidelines

This section lists the commands you use to configure CLI-based packet mirroring.
classifier-group
!
!
analyzer device at 192.168.99.2, port 6500.
hosts1(config)#secure l2tp policy-list l2tp_toMirrorHQ
host1(config-policy-list)#classifier-group *
host1(config-policy-list-classifier-group)#mirror analyzer-ip-address 192.168.99.2
analyzer-virtual-router default analyzer-udp-port 6500 mirror-identifier 1
session-identifier 1
jwbooth@isptheatre.com and associate the secure policy with the user.
host1(config)#virtual-router lac
host1:lac(config)#mirror username jwbooth@isptheatre.com l2tp
secure-policy-list l2tp_toMirrorHQ
Now, when subscriber jwbooth@isptheatre.com logs in, the packet mirroring
session starts and the subscriber's replicated traffic is sent through the secure
IPSec tunnel to the remote analyzer device.
Subscriber ID
Method
------------------
username
Administrative state: enable
Reference count:
2
Classifier control list: *
mirror analyzer-ip-address 192.168.99.2 analyzer-virtual-router default
Referenced by interface(s):
TUNNEL l2tp:5/1/5
secure-input policy
TUNNEL l2tp:5/1/5
secure-output policy
Use to create a classifier group for a secure policy list and enter Classifier Group
Configuration mode.
In Classifier Group Configuration mode, you configure the mirror action for the
classifier group.
Secure Policy
Secure Policy List
Type
-------------
------------------
l2tp
l2tp_toMirrorHQ
Policy Table
------ -----
Configuring CLI-Based Packet Mirroring
Chapter 6: Packet Mirroring
Sessions
Mirrored
--------
1
!
159

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Erx-710Erx-310Erx-1440Erx-1410Erx-705

Table of Contents