Mounting The Switch In A Rack; Attaching The Optional Cable Guide - Cisco WS-C2950T-48-SI Hardware Installation Manual

Installing the Switch

Mounting the Switch in a Rack

After attaching the brackets, use the four Phillips machine screws to securely attach the brackets to the
rack, as shown in
When installing a switch other than an LRE switch, to prevent the cables from obscuring the switch and
other devices in the rack, you can also attach the cable guide to the rack. See
Cable Guide"
Figure 2-16 Mounting the Switch in a Rack
After mounting the switch in the rack, start the terminal-emulation software, and provide power to the
switch. See the getting started guide for instructions.

Attaching the Optional Cable Guide

We recommend attaching the cable guide to prevent the cables from obscuring the front panels of the
switch and other devices installed in the rack. Use the supplied black Phillips machine screw to attach
the cable guide to the left or right bracket, as shown in
You cannot use the cable guide with Catalyst 2950 LRE switches.
Note
Figure 2-17 Attaching the Cable Guide
Catalyst 2950 Switch Hardware Installation Guide
2-16
Figure 2-16.
section for instructions.
SYS T
1x
RPS 2x
3x
4x
STAT 5x
UTIL DUP LX 6x
SPE ED
7x
8x
9x
MOD E
10 x
Number-12
Phillips machine
screws
SYS T
1x
RPS 2x
3x
4x
STAT 5x
UTIL
DUP LX SPE ED 6x
7x
MOD E
Cable guide screw
10B ase -T
/ 100 Ba se-
TX
11 x
12 x
13 x
14 x
15 x
16 x
17 x
18 x Ca tal ys t 29
19 x
50
20 x
21 x
22 x
23 x
24 x
Figure
8x 10B ase -T
9x / 100 Bas
10x e-T X
11x
12x
13x
14x
15x
16x
17x
18x
19x
20x
21x
22x
23x
24x
Chapter 2
the"Attaching the Optional
SER IES
2-17.
Ca tal yst 29
50
SER IES
Installation
OL-6156-01