Interior Light - Husky C1H-865 User Manual

General operating instructions for all models
Operating Instructions

INTERIOR LIGHT

The interior light may be switched on or off using the rocker switch on the inside right-hand wall
of the cabinet (see Fig. 2 on page 7).
REPLACING LED LIGHTS
1. Disconnect the chiller from the power supply.
2. Remove the light cover, pull out the wires and remove the LED lights.
3. Install the new LED lights, connect the wires, and replace the light cover.
4. Reconnect the chiller to the power supply.
INSTALLING SHELVES
Fit the shelf clips to the ladder racks (see Fig. 3 on page 7) and install the shelves horizontally.
Ensure the clips are located firmly and the shelves are secure before loading the chiller.
EASY MAINTENANCE ACCESS
Switch the unit off and disconnect from the mains supply.
compartment, simply remove the screws securing the rear access panel – see Fig 4 on page 7.
Any repairs or maintenance, other than CLEANING (see below) must be carried out by
QUALIFIED ENGINEERS ONLY.
CLEANING
The condenser and the compressor compartment MUST be cleaned quarterly. Switch the unit
off and disconnect from the mains supply. See 'Easy Maintenance Access' how to access the
compressor compartment. Use a vacuum cleaner fitted with a soft brush attachment to remove
dust carefully from the condenser, the components and grilles – see Fig 5 on page 7.
The external and internal surfaces of the unit should be cleaned regularly. Switch the unit off
and disconnect from the mains supply. Clean the external and internal surfaces of the unit with
a mild soap solution, then wipe dry. Do NOT use cleansers containing chlorine or other harsh
cleansing agents, as these can damage the stainless steel surfaces and components. Use mild
soapy water to clean the gasket and seals.
GETTING SERVICE ASSISTANCE
The cooling system is a hermetically sealed circuit and does not require any maintenance other
than regular cleaning (see 'Cleaning').
If the unit fails to work, first check the power supply. If you cannot locate the reason for the
failure, please contact your supplier, stating the model and serial number of the cabinet. You
may find this information on the rating plate, which is affixed inside the unit on the top right-hand
interior wall.
6
Exploded Diagrams
To access the compressor
To access the compressor
ii
compartment:
i. Remove the two screws.
iii
ii. Push the removable panel
down slightly to free it
i
from the securing flange.
iii. Angle the removable panel
forwards and down to
remove it.
7