Changing The Light Bulb; Defrosting; Troubleshooting; Power Failure - Husky Drinks Refrigerator Owner's Manual

6

CHANGING THE LIGHT BULB

Note: all parts removed should be kept safely. You will require these for the
reinstallation of the door.
Before removing the light bulb, YOU MUST UNPLUG THE UNIT. FAILURE
TO DO SO MAY RESULT IN ELECTRICAL SHOCK OR PERSONAL INJURY.
• Remove the light bulb cover (4) by gently pulling the bottom edge
of the light bulb cover.
• Unscrew the bulb (1) Fit a 10w refrigerator bulb that is the same
shape and size. Replace the light cover.
WHEN NOT IN USE FOR LONG PERIODS
• Unplug your Husky Drinks Refrigerator.
• Clean and dry the inside of the appliance. Leave the door slightly
open to allow it to dry completely.
• A chiller which is unused without being cleaned may start to smell
musty or develop mildew.

DEFROSTING

The surface of the evaporator ices up when the refrigerator is working. This
is an entirely normal part of operation. If the frost layer is more than
3mm / 1 ⁄ " thick, the refrigerator must be defrosted and cleaned to avoid
8
unnecessary energy consumption and inefficient operation.
• Remove all items inside and unplug the unit.
• After defrosting, clean the unit (see instructions below) and allow it
to dry. Reconnect to the mains supply and follow the directions
'OPERATION' on page 5.
CLEANING
To ensure efficient operation the back and bottom of the chiller should be
cleaned thoroughly. Note: do not use abrasive cleaners!
• Unplug your Husky Drinks Refrigerator.
• Wipe the interior with warm water and neutral detergent.
• Dry all surfaces thoroughly.
• Use mild soapy water to clean the door seal.
MOVING YOUR HUSKY DRINKS REFRIGERATOR
• Unplug the appliance
• Remove all items inside
Note: never hold the appliance by the door.
H U S K Y D R I N K S R E F R I G E R A T O R H U S K Y D R I N K S R E F R I G E R A T O R

Power Failure

• If a power cut occurs, do not open the door more often than
necessary in order to conserve cold air.

TROUBLESHOOTING

Before returning your Husky Drinks Refrigerator to the store, check the
following points; you may be able to solve any problem yourself.
Problem Solution
Your Drinks Refrigerator does • Check power cable is plugged in and
not operate switched on.
• The circuit breaker has tripped or the
fuse has blown.
• The temperature control is set at "O".
Your Drinks Refrigerator is • The temperature control dial may be
too cold set too high.
Your Drinks Refrigerator is not • Check the temperature control
cold enough dial is set at "3".
• A higher external ambient tempera-
ture may require a higher setting.
• The door is opened too often.
• The door is not closed completely.
• The door gasket does not seal
properly.
• The Drinks Cooler does not have the
correct clearances at the sides/back.
The defrosting water • Check if the coolers drain pan is full.
overflows inside the drinks
cooler and onto the floor
The side panel heats up • This is a result of the dissipation of
the heat from inside the cabinet.
Condensation forms on the • Condensation will form on the
outside of the drinks cooler outside of the drinks cooler if it
operates in moist areas, simply
wipe it dry.
The drinks cooler seems to • Appliance is not on a level, firm
make too much noise surface or may be touching other items.
• Note it is normal to hear refrigerant
flowing as the compressor stops and starts.
7