Water Pump - Winnebago Fuse 23A 2019 Operator's Manual

SECTION 7 –
PLUMBING
Fresh (City) Water Inlet
-Typical View
3. Turn on the external water source.
Disconnecting from City Water
1. Turn the city water source OFF.
2. Open a faucet on the motorhome (such as the
exterior wash station, if equipped) to relieve
line pressure.
3. Disconnect the city water hose from the
motorhome and replace the cap on the fresh
water inlet.

WATER PUMP

When your motorhome is not connected to a
city water supply, water is supplied from the
fresh water tank by a water system demand
pump. A demand pump is designed to run only
when you are using water. When you open a
faucet, the waterline pressure drops and the pump
begins to run, and it will continue to run as long
as the faucet is open. When you close the faucet,
the line pressure backs up to the pump, and it
shuts itself off.
The pump is self-priming and will run briefly
to build up line pressure when the Water Pump
switch is first turned on. See "Initial Waterline
Priming" for instructions on using the water
system for the first time.
Water Pump Strainer
The pump is equipped with a cleanable
strainer to capture any possible tank-borne
particles that could damage pump components.
7-2
NOTE: We recommend that you check and clean
the strainer after each tankful of water
during the first few uses of the Water
Pump system. Thereafter, remember to
check it at least yearly, and be sure to
empty water from it if using the blowout
winterization procedure.
Water Pump Strainer
-Typical View
To Clean Pump Strainer
• Ensure all Water Pump switches are OFF.
• Twist the inlet cap (bowl) "counter-
clockwise" to unscrew from the strainer
assembly.
• Remove the bowl and pull the strainer screen
out of the bowl to tap out any particles and
rinse clean.
• Insert the strainer screen back into the bowl,
then screw the bowl back onto the strainer
assembly.
Water Pump Switch
The Water Pump switch is located near the
monitor panel (some models may have an
additional switch in the water service center, near
the exterior shower, or within the bathroom area
for your convenience).
While the switch is "ON", the pump will
automatically supply water as it is needed.
We recommend that you turn the Water Pump
switch off whenever you will be away from the
vehicle or not using the water system. In time, a
Unscrew bowl
and remove to
clean strainer