Slideout Rooms; Slideout Room Lock System; Slideout Room Operation - Electric - Winnebago Fuse 23A 2019 Operator's Manual

SECTION 10 – SLIDEOUT ROOMS
SLIDEOUT ROOM LOCK
SYSTEM
The ignition key must be placed in the on or
run position to operate the slideout room(s). The
park brake must be applied for the room(s) to run.
Winnebago recommends running the engine
whenever you run the slideout rooms in or out,
the engine alternator should insure the rooms
have adequate 12-volt DC power to operate
correctly.
SLIDEOUT ROOM OPERATION
– ELECTRIC
WARNING
Your motorhome may have more than
one slideout room. Understand which
switch operates which slideout room prior
to operation. Make sure all slideout rooms
are clear of people who could be harmed
or obstacles that could cause damage
prior to operating any slideout rooms.
Failure to observe can result in death or
serious injury.
Slideout rooms provide a spacious living area
at the push of a button.
Front slideout room switches are typically
located near the Systems Monitor Panel.
Location varies by model and floorplan.
Rear slideout switches are typically located on
a wall in the rear of the motorhome in or near the
slideout room. Location varies by model and
floorplan.
Slideout Switch
(Your motorhome may have one or more
slideout switches depending on model,
options, and available equipment)
-Typical View
C AUT ION
Never drive the vehicle with a slideout
room extended!
The slideout room system uses 12-volt DC
motorized mechanisms with an electronic control
system to provide smooth operation and positive
weather seal.
NOTE: We recommend that you KEEP THE
ENGINE RUNNING WHILE
EXTENDING OR RETRACTING
SLIDEOUT ROOMS so the engine
alternator can provide maximum power
for proper operation of the slideout
mechanisms.
10-1