Bathroom; Doors And Windows - Winnebago Fuse 23A 2019 Operator's Manual

SECTION 11 –
MAINTENANCE AND STORAGE
• Remove spills immediately with a damp
cloth, followed by rinsing with clean water.
• The use of stiletto heels is not recommended,
as they may cause permanent damage to the
flooring.
• Protect flooring from prolonged direct
sunlight exposure.
Treatment of Stains
Acids, alkali, alcoholic beverages, coffee, soft
drinks, ketchup, fruit, fruit juices, food,
vegetables, mustard, ink, and iodine:
• Remove the stain with lukewarm water and a
cloth or sponge. If necessary, clean with a soft
nylon pad and non-abrasive mild detergent or
resilient floor cleaner.
Heel marks:
• Clean as soon as possible with a soft nylon pad
and non-abrasive mild detergent or resilient
floor cleaner.
Asphalt, candle grease, chewing gum, fat, oil,
tar, and shoe polish:
• Gently remove with a blunt instrument and
treat with a soft nylon pad and non-abrasive
floor cleaner.
Lacquer and nail polish:
• Remove as soon as possible. Do not allow to
dry. If necessary, apply nail polish thinner
(sparingly) to remove any residue.
Corrosion, paint, and grass stains:
• Treat as soon as possible with a soft nylon pad
and non-abrasive mild detergent or resilient
floor cleaner.
Varnish, oil paint, and solvents:
• Blot up as soon as possible. Do not rub, as this
will only spread material further across the
surface. Carefully treat with a mild cleanser.
When dry, carefully peel the stain off.
MEK may be used sparingly, if necessary.
Rinse immediately with clean water.
Pet stains:
• Treat with lukewarm water. If stain remains
visible, clean with a soft nylon pad and non-
abrasive resilient floor cleaner.
11-8

BATHROOM

Toilet
For instructions on the care of your toilet, refer
to the information in your InfoCase.
Tub and Shower Walls
The tub and shower walls in the bathroom
should be cleaned with mild soap and warm
water. Do not use an abrasive cleaner on the
shower walls and tub, as scratching and
discoloration may occur. Stubborn stains may be
removed with an automotive-type cleanser.
Lavatory Sink - Fiberglass
General Cleaning
Clean often with hot water and soap. If a
cleanser is necessary, make sure the product is
recommended for use on plastics.
Avoid harsh abrasive cleaners, ammonia, or
citric-based products as discoloration may result.
Rinse all food, beverage, or cosmetic residue
from the sink as soon as possible. Some residues,
if left to sit in the sink, may require the use of
detergent or mild liquid or gel-type kitchen
surface cleaner.
If acids or medicine spill on the surface, wash
the spills immediately.
Marks or Discoloration
A color-matched automotive scratch remover
compound may be used to remove stubborn
marks or discoloration. Always follow label
directions.
NOTE: Do not use steel wool or metal scouring
pads.

DOORS AND WINDOWS

Windows may be periodically cleaned with a
good quality glass cleaner or mild soap solution
using a soft cloth.
Use care when removing ice or frost from the
windows. Always use a plastic ice scraper, never
one made of metal. Use care when removing ice
from the mirrors to protect the reflective surfaces.