Setting IP Addresses
Preparations for Work
1.
Network Configuration
The network configuration that is described in this manual is shown in the following figure.
Connect the Reader/Writer and the computer with an Ethernet Cable.
Reader/Writer
Ethernet Cable
2.
Set the IP address on the computer.
Set the IP addresses on the computer. The default IP addresses of the Reader/Writer are given in the following table. Use these
addresses to set the IP address on the computer. This example changes the last part of the IP address to a value other than 200
(i.e., to 1 to 199 or 201 to 254). Values of 0 and 255 cannot be used.
Default IP Addresses of the Reader/Writer
Setting
IP address
Subnet mask
Default gateway
Switching Hub
Ethernet Cable
Default setting
192.168.1.200 (fixed setting)
255.255.255.0 (fixed setting)
192.168.1.254 (fixed settings)
Preparations for Communications
Computer
Section 5
RFID System
83
User's Manual
(PROFINET)