Section 5 • Diagnostic Codes
REV A
Observe and Obey:
Troubleshooting and repair procedures shall be
completed by a person trained and qualified on
the repair of this machine.
Immediately tag and remove from service a
damaged or malfunctioning machine.
Repair any machine damage or malfunction
before operating the machine.
Before Troubleshooting:
Read, understand and obey the safety rules and
operating instructions in the Genie S-100 &
Genie S-105 Operator's Manual and the
Genie S-120 & Genie S-125 Operator's Manual.
Be sure that all necessary tools and parts are
available and ready for use.
5 - 10
About This Section
This section explains various parts of the machine
software operating system and how to access
some of the adjustable parameters of the control
system.
Web GPI
The software system used on the machine is called
Web GPI. It is a software application that is
typically used with a laptop computer. The laptop
can be connected to the ground controls via a tee
harness connector (Genie part number 75094).
The Web GPI software can access all adjustable
parameters for the machine. It can also be used to
aid in troubleshooting and viewing fault code
history.
S-100 • S-105 • S-120 • S125
June 2011
Software
REV A
Part No. 102916