The disc was recorded in Video mode.
Cannot play a disc
recorded using this
Some players will not play even a
recorder on another
finalized disc recorded in Video mode.
The disc was recorded in VR mode,
Discs recorded with copy-once material
cannot be played on other players.
Cannot record or did
The remaining blank space on the
not record successfully.
disc is insufficient.
The source you are trying to record is
When setting the recording channel, the
channel is tuned on the TV's own tuner.
When recording to a Video mode disc,
programs that are copy-once
protected cannot be recorded.
Timer recording is not
Clock in recorder is not set to correct
Timer has been programmed
Timer record indicator light does not
appear after programming timer.
Stereo Audio Record
TV is not Stereo-compatible.
and/or Playback is not
Broadcast program is not in stereo
The recorder A/V Out jacks are not
connected to TV A/V In jacks.
The recorder Audio/Video Out is not
selected for viewing at the TV.
The recorder's TV audio channel is
set to mono.
The remote control
The remote control is not pointed at
does not work properly.
the remote sensor of the recorder.
The remote control is too far from the
There is an obstacle in the path of the
remote control and the recorder.
The batteries in the remote control
Resetting the recorder
If you observe any of the following symptoms...
The unit is plugged in, but the power will not turn
on or off.
The front panel display is not working.
The recorder is not operating normally.
...you can reset the recorder as follows:
Press and hold the POWER button for at least five
seconds. This will force the unit to power off then
turn the unit back on.
Unplug the power cord, wait at least five seconds,
and then plug it in again.
Finalize the disc. (page 21)
The other player must be RW
compatible in order to play it.
Use another disc.
You cannot record the source.
Select the channel on the recorder's
built-in TV tuner.
Use a VR mode formatted disc for
Set clock to correct time. See "Clock
Set" on page 17
Reprogram Timer. See "Timer
Recording" on page 35.
Make A/V connections. Stereo is
available only via A/V output from the
Select AUX or A/V source as TV
Set TV audio channel mode to Stereo.
See "Changing TV audio channel" on
Point the remote control at the remote
sensor of the recorder.
Operate the remote control within
Remove the obstacle.
Replace the batteries with new ones.