Connections to Your TV
Make one of the following connections, depending
on the capabilities of your existing equipment.
Turn off your unit before you set the VIDEO OUT
SELECT switch. When using the COMPONENT/
PROGRESSIVE SCAN VIDEO OUT jacks, set the
VIDEO OUT SELECT switch to COMPONENT.
When using the SCART jack, set the VIDEO OUT
SELECT switch to RGB.
Depending on your TV and other equipment you
wish to connect, there are various ways you could
connect the recorder. Use only one of the
connections described below.
Please refer to the manuals of your TV, VCR,
Stereo System or other devices as necessary to
make the best connections.
Make sure the recorder is connected directly to the
TV. Tune the TV to the correct video input channel.
Do not connect the recorder's AUDIO OUT jack to
the phono in jack (record deck) of your audio
Do not connect your recorder via your VCR. The
DVD image could be distorted by the copy
Rear of TV
COMPONENT VIDEO INPUT
Rear of the unit
Connect the S-VIDEO OUT jack on the recorder to the
S-Video in jack on the TV using the S-Video cable (S).
Connect the VIDEO OUT jack on the recorder to the
video in jack on the TV using the video cable (V).
Audio (Left/Right) Connection
Connect the left and right AUDIO OUT jacks of the
recorder to the audio left and right IN jacks on the TV
using the audio cables (A). Do not connect the
recorder's AUDIO OUT jack to the phono in jack
(record deck) of your audio system.
Component Video connection
Connect the COMPONENT / PROGRESSIVE SCAN
VIDEO OUT jacks on the recorder to the
corresponding input jacks on the TV using an Y Pb Pr
If your television is a high-definition or "digital ready"
television, you may take advantage of the recorder's
progressive scan output for the highest video
resolution possible. If your TV does not accept the
Progressive Scan format, the picture will appear
scrambled if you try Progressive Scan on the recorder.
Set the [Progressive Scan] option to [ON] on the
setup menu for progressive signal, see page 17.
Progressive scan does not work with the analog video
connections (yellow VIDEO OUT jack) or S-VIDEO
Connect the EURO AV1 AUDIO/VIDEO scart jack on
the recorder to the corresponding in jacks on the TV
using the scart cable (T).
Once the setting for Progressive Scan output is
entered, an image will only be visible on a
Progressive Scan compatible TV or monitor. If you set
Progressive Scan to [ON] in error, you must reset the
recorder. First, remove the disc in the recorder. Next,
press STOP (x) and hold it for five seconds before
releasing it. The video output will be restored to the
standard setting, and a picture will once again be
visible on a conventional analog TV or monitor.