12.47
Removing the engine guard (EXC‑F AU, EXC‑F Six Days)
12.48
Installing the engine guard (EXC‑F AU, EXC‑F Six Days)
–
Inject the liquid into the system until it escapes from open-
6
ings
of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws
bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
E00339-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
Remove screws
H01638-10
–
Attach the engine guard on the frame at the rear and swing up
at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
H01638-10
12 SERVICE WORK ON THE CHASSIS
4 mm (0.16 in)
1
and engine guard.
1
.
M6
10 Nm (7.4 lbf ft)
95