Install Hearth Components, Logs And Embers - Heat & Glo SL-5 Installation Manual

E. Install Hearth Components, Logs and
Embers
Install Hearth Components
The left, middle, and right hearth components are packaged
in a separate box that is shipped inside the firebox. The
three hearth components are shown in Figure 11.2.
Note: The left and right components have indentations that
will be used to locate and correctly position the rear logs.
The hearth components may fit together tightly. Ensure
that excess flashing on the edges of the hearth components
has been removed to provide optimal fit.
LOG INDENTATIONS
LEFT CENTER
Figure 11.2 Hearth Components
1. Locate the left hearth component shown in Figure
11.2. Place it as shown in Figure 11.3, ensuring that
the outer edge of the hearth component firmly contacts
the firebox side and the front edge contacts the firebox
front lip. Gently push "down" on the indentation to force
the bottom side of the hearth component to engage
the screw tips on the bottom of the firebox.
FIREBOX SIDE
FIREBOX
FRONT LIP
Figure 11.3 Install Left Hearth Component
2. Locate the center hearth component shown in Figure
11.2 and install it adjacent to the left hearth component
as shown in Figure 11.4.
60
RIGHT
Heat & Glo • SL-5, SL-7, SL-9 Installation Manual • 2392-980 Rev. L • 6/17
Figure 11.4 Install Center Hearth Component
3. Locate the right hearth component as shown in Figure
11.2. Install right hearth component by pointing its left
tip at a slight angle as shown in Figure 11.5. When
the right end of the middle hearth piece and the left
tip of the right hearth component engage, gently place
them in position. Push "down" on the indentation on
the right hearth component to engage the screw tips
at the bottom of the firebox.
Figure 11.5 Lift Center Hearth Component While Placing Right
Hearth Component
Figure 11.6 Hearth Components Installed
SLIGHT ANGLE