Decorative Front Finishing - Heat & Glo SL-5 Installation Manual

C. Decorative Front Finishing
Only decorative fronts certified for use with this appliance
model may be used. Contact your dealer for a list of dec-
orative fronts that may be used. Once you have deter-
mined what kind of decorative front and finishing material
is going to be used on the fireplace, use the information
below which shows the decorative front models and the
non-combustible finishing material thickness allowed.
Note:
Refer to Section 3 for individual decorative front
dimensions as installed on appliance.
Inside Fit - Firescreen Front (0-4 Inch Finishing)
DECORATIVE FRONT
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
Stop finishing material flush with fireplace surround opening.
Figure 10.8 Firescreen Decorative Front
Overlap Fit - ARC,CHA,HAL, & CHAF (1-4 Inch Finishing)
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
(Includes additional clearances to sides and top of decorative front)
Finishing material between 1 and 4 inches thick.
Refer to Section 3 for X and Y dimensions.
Figure 10.9 Overlap Fit Decorative Front (ARC, CHA, CHAF, HAL)
58
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
DECORATIVE FRONT
Y
X
Heat & Glo • SL-5, SL-7, SL-9 Installation Manual • 2392-980 Rev. L • 6/17
Adjustable Overlap Fit
FRONT FACE OF FIREPLACE
DECORATIVE FRONT
Finishing materials 1 inch maximum thick.
Stop finishing material flush with opening.
Figure 10.10 Overlap Fit Decorative Front
1 IN. MAX.
FINISHING MATERIAL
(TOP EDGE)