Using Presets; Recall Preset - B&K AVP1030 Owner's Manual

You have completed the setup procedure. Remember, you have to perform the
calibration procedure every time you change your speaker configuration.
There are 20 A/V presets provided. Presets "0" through "9" are selected using the
numeric buttons on the remote (0-9). Pressing the "A" button first allows you to select
bank "A" presets, "A0" through "A9", using the same numeric buttons (0-9).
The preprogrammed audio/video presets let you instantly select any of the audio/video
sources along with volume level and surround mode settings. You can customize the
presets, including the preset name, for ease of operation.
Recall a preset
Using the remote control, press a number on the keypad to display the preset name.
Pressing "A" selects "bank A". Once you press a preset number, you can then press x
or y to step through all the preset names. If the AVP is off, pressing a preset number
will turn the preamplifier on, then pressing ENTER will select that preset.
Keypad
number
    
0
 
1
2
!  
3
"  
4
Select the desired preset then press ENTER to recall. The display will show (if you
selected preset #1):
Save a preset
A preset will save the following information in a preset for you:
Master volume, Selected input, Input mode (analog, PCM, or Dolby Digital)
Surround mode, rear volume, subwoofer volume, center channel volume, delay

Using presets

Display shows
 
 
Keypad
number
5
6
7
8
9
Page 26
Display shows
   
$  
%  
&  
'