Setup & Preparation - Ozito ELM-1030U Original Instructions Manual

SETUP & PREPARATION
2. ASSEMBLY
WARNING!:
ENSURE THE TOOL IS DISCONNECTED
FROM THE POWER SUPPLY BEFORE ASSEMBLY
Fitting the Lower Handle to Mower Body
1. Fit the lower handle onto the
threaded ends.
Fitting the Upper Handle to the Lower Handle
1. First fit the cord retainer, slide
it over the upper handle end
before fixing the upper handle
to the lower handles.
2. Place the upper handle over
the upper ends of the lower
handle. From the handle
securing set, fit the bolts
through the inner side of
the lower handle and then
through the holes in the upper
handle. Secure in place by
screwing the handle securing
knobs over the protruding
ends of the bolts.
.
2. Fit and secure in place with
the lower handle knobs.
Securing the Power Cord to the Handles
1. Secure the power cord from the
switch housing to the mower using
cable ties (supplied).
Assembling the Grass Catcher
1. Assemble the grass catcher
handle onto the opening
on the top half of the grass
catcher. The handle will click
into position when aligned
and fitted correctly.
Fitting and Removing Grass Catcher
The catcher must be attached to the two raised hooks on the mower.
1. Lift up the catcher flap with one
hand and guide the catcher over
the two hooks on the mower
housing.
2. Lower the grass catcher in place
and lower the catcher flap. The
catcher flap is held against the
gass catcher by a spring
3. To empty the grass catcher, lift
the catcher flap with one hand
then lift the grass catcher with
the other hand up off the two
raised housing clips.
WARNING!: WHEN ASSEMBLING THE GRASS
CATCHER BACK TO THE MOWER AFTER
EMPTYING, ALWAYS ENSURE THERE IS NO BUILD
UP OF GRASS IN THE GRASS CHUTE. IF NEEDING TO
CLEAR THE GRASS, ALWAYS ENSURE THE MOWER
IS DISCONNECTED FROM THE POWER SUPPLY
PRIOR TO CLEARING. A BUILD UP OF GRASS IN THE
GRASS CHUTE MAY PREVENT GRASS FROM MOVING
INTO THE GRASS CATCHER EFFECTIVELY.
2. To assemble the grass catcher
align the two halves and push
them together, one side at a
time. Ensure the two halves click
together around the entire middle
section.
"CLICK"
"CLICK"
"CLICK"