Table of Contents
Advertisement
Each of the following activities are performed in programming
Area 07. From the main menu, use [ ⇑ ], [ ⇓ ] or enter "07" on the
keypad to scroll to "Telephone Entry Numbers, Enter Program
Area 07" and press [OK]. Press [
the main menu.
Entering Tenant Names & Numbers
Use [ ⇑ ] or [ ⇓ ] to scroll to "Enter Directory Code".
Enter the tenant's directory code number and press [OK]. (This will be
the number displayed on the AE-1 that the guest enters to make the
unit dial the tenant.)
Enter the tenant's name (up to 24 characters, but only the first 16 can
be displayed on the current Model AE-1) and press [OK]. (This will be
the text displayed as the tenant's name.)
Enter the tenant's telephone number and press [OK]. (This is the actual
telephone number of the tenant's telephone. For security, it will not be
displayed on the AE-1 and cannot be viewed by the guests.) Do not
include a PBX dialing digit (if a dialing digit is required, it has been
pre-programmed by the installer).
Use [⇐] or [⇒] to choose "YES" or "NO" for "Extended Talk Time".
Press [OK] when the desired selection is blinking.
Extended talk time allows the tenant to talk up to 250 seconds to the
guest at the AE-1. Regardless of this programming option, the tenant
can always press the telephone's # key to talk longer. The tenant will
hear beeps during the last 10 seconds of talk time programmed.
Pressing the telephone's # key during the beeps will extend the allotted
time 50% of the talk time programmed.
To enter additional tenant information, repeat Steps 1-5.
AREA 07
TELEPHONE ENTRY NUMBERS
AREA 07
TELEPHONE ENTRY NUMBERS
Enter Directory Code
Directory Code: 0000
Enter Tenent Name
Enter Telephone Number
Telephone#: ************
Extended Talk Time
Yes No
Delete Directory Entry
Directory Code: 0000
] when finished to return to
*
Area 07 is used to enter and delete telephone directory
codes, tenant names and select extended talk time for users.
7.1
7.2
7.3
7.4
7.5
Deleting Directory Entries
Use [ ⇑ ] or [ ⇓ ] to scroll to "Enter Directory Code".
Enter the tenant's directory code number to delete and press [OK].
To delete additional tenant entries, repeat Steps 1 & 2.
9
Advertisement
Table of Contents
