Each of the following activities are performed in programming
Area 06. From the main menu, use [ ⇑ ], [ ⇓ ] or enter "06" on the
keypad to scroll to "Block Card Codes, Enter Program Area 06"
and press [OK]. Press [
] when finished to return to the main
*
menu.
Entering Block Card Codes
Use [ ⇑ ] or [ ⇓ ] to scroll to "Enter Block Cards".
Use [⇐] or [⇒] to choose a validation group for the transmitter block.
Press [OK] when desired selection is blinking.
Enter the numbers for the start and the end of the card block and press
[OK].
To enter additional block card codes, repeat Steps 1-3.
Suspending Block Card Codes
Use [ ⇑ ] or [ ⇓ ] to scroll to "Enter Card Number".
Enter the card number to suspend and press [OK].
Use [ ⇑ ] or [ ⇓ ] to select "Suspend Block Card" and press [OK].
To suspend any additional block cards, repeat Steps 1-3.
Reactivating Block Card Codes
Use [ ⇑ ] or [ ⇓ ] to scroll to "Enter Card Number".
Enter the card number to reactivate and press [OK].
Use [ ⇑ ] or [ ⇓ ] to select "Reactivate Block Card" and press [OK].
To reactivate additional block cards, repeat Steps 1 & 2.
8
AREA 06
BLOCK CARD CODES
BLOCK CARD CODES
Enter Block Cards
Press OK when Ready
Enter Card Number
Enter ID Number: 00000
Suspend Block Card.
ID Number
: [00000]
Reactivate Block Card.
ID Number
: [00000]
Status of Block Card.
ID Number
: [00000]
Delete All Block Cards.
Are You Sure? Yes No
Area 06 is used to enter, suspend, reactivate, delete, and
check the status of swipe cards entered as a block. A
validation group can be selected for each card block when it
AREA 06
6.1
Enter Validation Group.
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
6.2
Enter Block Range
Start:End 00000:00000
6.3
6.3
6.4
6.5
Item/Code:
Press OK When Ready
6.6
Status of Block Card Codes
Use [ ⇑ ] or [ ⇓ ] to scroll to "Enter Card Number".
Enter the card number for status and press [OK].
Use [ ⇑ ] or [ ⇓ ] to select "Status of Block Card" and press [OK].
To view status of additional block cards, press [OK] then repeat Steps 1-3.
Deleting All Block Card Codes
NOTE: Facility Managers should not use this function. Contact the
Installer for making any complex or critical programming changes.
is entered into memory.
6.1A
6.1B
6.5A