Table of Contents
Advertisement
Enter Block Xmtr(s).
Enter Transmitter Numb
Suspend Block Xmtr.
ID Number
Reactivate Block Xmtr.
ID Number
Status of Block Xmtr.
ID Number
Delete All Block Xmtrs.
Are You Sure? Yes No
Each of the following activities are performed in programming
Area 02. From the main menu, use [ ⇑ ], [ ⇓ ] or enter "02" on the
keypad to scroll to "Block Transmitter(s), Enter Program
Area 02" and press [OK]. Press [
the main menu.
Entering Block Transmitters
Use [ ⇑ ] or [ ⇓ ] to scroll to "Enter Block Xmtr(s)".
Use [⇐] or [⇒] to choose a validation group for the transmitter block.
Press [OK] when desired selection is blinking.
Enter the numbers for the start and the end of the transmitter block and
press [OK].
To learn additional block transmitters, repeat Steps 1-3.
Suspending Block Transmitters
Use [ ⇑ ] or [ ⇓ ] to scroll to "Enter Transmitter Numb".
Enter the transmitter ID# to suspend and press [OK].
Use [ ⇑ ] or [ ⇓ ] to select "Suspend Block Xmtr" and press [OK].
To suspend any additional transmitters, repeat Steps 1-3.
Reactivating Block Transmitters
Use [ ⇑ ] or [ ⇓ ] to scroll to "Enter Transmitter Numb".
Enter the transmitter ID# to reactivate and press [OK].
Use [ ⇑ ] or [ ⇓ ] to select "Reactivate Block Xmtr." and press [OK].
To reactivate additional transmitters, repeat Steps 1 & 2.
6
AREA 02
BLOCK TRANSMITTERS
BLOCK TRANSMITTERS
Press OK when Ready
Enter ID Number: 00000
: [00000]
: [00000]
: [00000]
] when finished to return to
*
Area 02 is used to enter, suspend, reactivate, delete, and
check the status of block coded transmitters. A validation
group can be selected for each transmitter block when it is
AREA 02
2.1
Enter Validation Group.
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
2.2
Enter Block Range
Start:End 00000:00000
2.3
2.4
2.5
Item/Code:
Press OK When Ready
2.6
Status of Block Transmitters
Use [ ⇑ ] or [ ⇓ ] to scroll to "Enter Transmitter Numb".
Enter the transmitter ID# for status and press [OK].
Use [ ⇑ ] or [ ⇓ ] to select "Status of Block Xmtr." and press [OK].
To view status of additional transmitters, press [OK] then repeat Steps 1-3.
Deleting All Block Transmitters
NOTE: Facility Managers should not use this function. Contact the
Installer for making any complex or critical programming changes.
entered into memory.
2.1A
2.1B
2.5A
Advertisement
Table of Contents
