Table of Contents
Advertisement
Maestro
Apogee Maestro is a controller software for your Symphony I/O. Though you do not need Maestro open to use your
Symphony I/O, it provides access to all of Symphony's settings and parameters. Its level meters are also a useful
diagnostic tool to see which inputs and outputs are receiving and sending signal. Maestro can be used in all four AIMs.
Maestro Features
While only basic settings may be made from the front panel controls, all Symphony features are available and can be
controlled from Apogee Maestro software.
Device Icon and ID Button
A device icon and ID button is placed adjacent to each row of parameters to identify the hardware unit to
which the row belongs. By clicking on the ID button, the corresponding hardware unitʼs front panel will
illuminate. Each hardware unit is assigned a Peripheral Prefix (A-Z, found in Maestroʼs Device Settings tab
window) which is displayed on the ID button.
Toolbar
1
2
1. Clear Meters
This button clears all held peak and over indications on all hardware and software meters.
2. System Status
This window displays the sample rate, clock source, and system status of the currently selected system. A system
status of "Ready" indicates that all detected units are properly connected and clocked
3. Toolbar Monitor Controls
These controls offer immediate access to one peripheral's speaker and headphone volume controls, regardless of
the Devices Sidebar selection.
Symphony I/O - User's Guide
Devices Sidebar
Any Maestro-compatible Apogee interface connected to the host computer is displayed in the
Devices sidebar. Hardware settings are displayed by first selecting one or more interfaces in the
Devices sidebar and then clicking on a tab.
1
2
3
3
4
5
6
7
8
9
4
5
6
7
8
9
10
10
11
12
13
14
15
1
2
3
4
5
11
12
13
14
15
16
16
17
18
19
20
6
7
8
9
10
11
17
18
19
20
Page 54
1
Hide quick links:
Advertisement
Table of Contents
