HEIDENHAIN iTNC 530 Technical Manual page 560

Hide thumbs Also See for iTNC 530:

Table of Contents

PLCSOFTVERS =

PLCPASSWORD =

MPPASSWORD =

MPLOCKFILE =

February 2002

(mandatory entry): TNC displays PLC software version when the MOD key is

Input example: PLCSOFTVERS = BASIS--33-03

Path for compensation value tables for axis error compensation. (See

"Nonlinear Axis Error Compensation" on page 6 – 37)

Input example: TABCMA = PLC:\AXIS_COR\CORRECT.CMA

Path for help texts and machine commands.

Input example: MODEHELP = PLC:\LANGUAGE\GERMAN\OPTIMIER.HLP

Code number for calling the PLC mode (instead of 807667).

Input example: PLCPASSWORD = 123456789

Do not enter a code number that has already been defined by

Code number for calling the machine parameter file (instead of 95148).

Input example: MPPASSWORD = MP

Do not enter a code number that has already been defined by

Path of a machine parameter subfile. If there are differences between this file

and the current machine parameter file, an error message appears and the

value from this subfile is offered for acceptance.

Input example: MPLOCKFILE = PLC:\MP\340420.MPL

Path and file name for list of the tool types.

Path for event list (SPAWN command).

Input example: PLCEVENTS = PLC:\EVENTS.PEV

Timeout for block reception (STX to ETX).

Timeout for acknowledging ENQ or check sum.

Timeout during transmission of DLE 0, DLE 1 or NAK until reception of a valid

System Files