HEIDENHAIN iTNC 530 Technical Manual page 217

MP Function and input
MP7490 Functions for traverse ranges
Format:
Input:
MP7500 Tilting working plane
Format:
Input:
February 2002
%xxxx
Bit 0 –
0: Display one traverse range via MOD
1: Display three traverse ranges via MOD
Bit 1 -
0: Each traverse range has its own datum (and 3
memories for the positions of the swivel head)
1: One datum for all traverse ranges
Bit 2 – Calibration data: touch probe for
workpiece measurement:
0: One set of calibration data for all traverse
ranges
1: Every traverse range has its own set of
calibration data
Bit 3 – Calibration data: touch probe for tool
measurement:
0: One set of calibration data for all traverse
ranges
1: Every traverse range has its own set of
calibration data
%xxxxxxxxx
Bit 0 – "Tilted working plane"
0: Off
1: On
Bit 1 –
0: Angles correspond to the position of the tilting
axes of the head/table
1: Angles correspond to the spatial angle (the
iTNC calculates the position of the tilted axes of
the head/table)
Bit 2 –
0: The tilting axes are not positioned with Cycle
19
1: The tilting axes are positioned with Cycle 19
Bit 3 –
0: The current tilting-axis position is taken into
account with respect to the machine datum
1: The 0° position is assumed for the first rotary
axis
Bit 4 –
0: Compensate mechanical offset during
exchange of the spindle head when calling
M128, M114 or "tilted working plane"
1: Compensate mechanical offset during PLC
datum shift
List of Machine Parameters
Software Page
version and
behavior
PLC 6 – 23
RUN
PLC 6 – 79
RUN
4 – 57